Step 3, Channel Settings Configuring the Channel Settings follows the same pattern as the Installation procedure: Notice, that you can change the channel bandwidth, but it will of cause a re synchronization. La mise à la terre est assurée en reliant la fiche d'alimentation à une prise de courant avec une protection de terre. The following procedure is generic to all relevant Ceragon radio products. Click the Yes button and you are returned to the main window of the FibeAir2000 Manager. Many license codes, in turn, enable configuration keys that allow you to enable and disable functionality at a more detailed level.
The system is re-synchronized to the changes. It is updated to reflect your choice. Figure 1-22: External antennas - Grid Antenna See the Ceragon products catalog for Ceragon offering of external antennas. Little Falls, New Jersey, February 22, 2017 — Ceragon Networks Ltd. Same as Log Off Log Off button File Exit the FibeAir2000 Manager. The actual degree of lightning protection required depends on local conditions and regulations.
G-6 Montage d'une antenne externe. If you do not succeed, seek assistance from Ceragon Customer Support. Ceragon will showcase the new solutions next week at Mobile World Congress 2017 in Barcelona, Spain booth 5G61. The file information can be used for diagnostics and should be sent to Ceragon Customer Support to speed up assistance. A window similar to the following appears: Figure 8-2: Air interface details The only thing you may change here is the expected Tx power. Repeat for each of the event types. The link is encrypted with default keys.
The Configuration dialog box opens. It may be configured in cascaded links for multi-hop. You are then offered a standard Open File dialog box. Having problems with your product key? The configuration is independent at each port. Choose Operations in the Configuration dialog box. Only events from Ceragon equipment will be shown. The report also indicates the license code and menu items associated with each configuration key.
The latest authoritative and most up to date technical specifications are available as Data Sheets obtainable from Ceragon Customer Service. The following procedure is generic to all Ceragon radio products. This loopback is initiated by the managing computer connected to the local unit. Navigate to the Hot Standby tab, in the Services Configuration panel: Figure 12-4: Services Configuration Panel: Hot Standby mode selection Check the Primary button to configure Primary Link as the primary link. You may skip this section.
The Change Link Password dialog box opens. . Step 3: Follow the prompts to finish the redemption and setup process. Always restore the over-the-air site B first. Passer les deux courroies de fixation par les fentes verticales dans le support à pivot- ement.
You may have to find them elsewhere, depending on your system. Enterprise value captures the cost of an entire business, including debt and equity. The following functions are available from the left side of the dialog box. The products are designed to further help service providers address key 4. Notice that the Jitter Buffer is configured per site. If for some reason the default band needs to be changed, it should be done before link Installation.
Following a short delay for processing, Back and Next are enabled. Step 4: Select Install Office again in the window where the product key appears. Select the Frequency from the pull-down menu. The Virtual support agent can also let you know if your product key has been blocked and can connect you to a live agent. External anten- nas are also available from antenna vendors. See Chapter 10 for instructions about installing and configuring collocated links.